GetEasyComputerHelp.com Norton Internet Security Firewall/Networking

Home | Contact Us | Search | Support | Remote

Norton Internet Security and
Changing Firewall/Networking Settings

Click Here for a Printable Version of this Document

This change will allow you to use resources (printers and other peripherals) on a network.

First Find the Network Addresses you’re on. This will change from network to network and location to location.

Click Start, (All) Programs, Accessories, Command Prompt
When the black Command Prompt window opens type ipconfig (and press Enter)
Notice in the above example the IP address is 192.168.0.10. You will want to remember the 192.168.0 part (the first 3 sets of numbers).
Next open Norton Internet Security by right clicking on the icon in the system tray (down at the bottom right by the clock) and selecting Norton Internet Security

Next Double Left Mouse Click on Personal Firewall

Click the Networking Tab.

Click Add
Then add a Range
In the Start type in the 1st three sets of numbers from step3 (above) followed by 0 (zero). So, 192.168.0.0
In the End type in the 1st three sets of numbers from step3 (above) followed by 255. So, 192.168.0.255
Click OK.
And Close and you’re done.

Note:
GetEasyComputerHelp.com assumes no responsibility for problems resulting from using any of these tips or web sites listed. Please read our full Terms and Conditions if you have questions.

Note: GetEasyComputerHelp.com assumes no responsibility for problems resulting from using any of these tips or web sites listed. Please read our full Terms and Conditions if you have questions.

Note:
GetEasyComputerHelp.com assumes no responsibility for problems resulting from using any of these tips or web sites listed. Please read our full Terms and Conditions if you have questions.